Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Plainview, TX

Garage Door Replacement in Plainview, TX

Old or damaged doors replaced with a new door, springs, tracks and hardware. Typical cost $1,200-$5,000.

Garage doors rarely fail at a convenient time. If you need garage door replacement in Plainview, TX, we can often come out the same day when a technician is available. Old or damaged doors replaced with a new door, springs, tracks and hardware.

Is it time for garage door replacement?

  • Repair costs approach half the price of a new door
  • Discontinued panels that can't be matched
  • Rot, rust-through or warping
  • The door is more than 20 years old and needs major work

What usually causes it

  • Age and weather
  • Impact damage across several sections
  • Parts no longer available

Before the technician arrives

  • Compare the repair quote with the cost of a new door.
  • Check whether your opener is compatible or due for replacement too.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our garage door replacement process

  1. Price repair and replacement side by side
  2. Measure and order the new door
  3. Remove and dispose of the old door
  4. Install the new door with new springs and track
  5. Balance, seal and test

Garage Door Replacement cost in Plainview, TX

$1,200-$5,000Typical range, parts & labor
4-8 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Garage Door Replacement in Plainview, TX

For Texas homes, look at insulated steel or composite doors that resist moisture, and ask whether wind-load requirements apply to your area before you choose a model.

Parts of Texas are exposed to hurricanes and tropical storms. A garage door is often the largest opening in a home, so wind-rated doors and reinforcement kits matter here, and building codes in coastal areas may require them when a door is replaced.

Hailstorms are common in parts of Texas. Hail can dent steel panels and crack windows, and thicker-gauge or insulated doors resist dents better than thin single-layer steel.

Technicians serve all of Plainview (ZIP codes 79072 and 79073), plus Seth Ward (2.1 mi), Hale Center (11.4 mi), Tulia (24.4 mi) and Olton (24.5 mi). Call (833) 435-8883 to book a visit in Plainview.

Garage Door Replacement: frequently asked questions

How much does garage door replacement cost in Plainview, TX?

Garage Door Replacement typically costs $1,200-$5,000 including parts and labor, and usually takes 4-8 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do garage door replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is garage door replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Texas or Plainview requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Plainview, TX

Sommer Garage Door Sensor Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $100-$250

Hörmann Garage Door Panel Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $300-$900

Ryobi Remote & Keypad Programming

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $50-$150

Wayne Dalton Garage Door Roller Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$350

Richards-Wilcox Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Martin Door Garage Door Cable Repair

Frayed, snapped or slipped lift cables replaced and the door re-leveled.

Typical $150-$350

Craftsman Garage Door Sensor Repair

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $100-$250

Craftsman Remote & Keypad Programming

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $50-$150

Overhead Door Off-Track Garage Door Repair

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $175-$450

High-Speed Door Repair

Fabric and rigid high-speed doors repaired and recalibrated.

Typical $400-$2,000

Hörmann Extension Spring Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $150-$350

Hörmann Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Garage door stuck, noisy or broken?

Talk to a garage door technician in Plainview, TX now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote