Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Plainview, TX

Weather Seal Replacement in Plainview, TX

New bottom seals, threshold seals and perimeter stops to keep out water and drafts. Typical cost $100-$300.

Garage doors rarely fail at a convenient time. If you need weather seal replacement in Plainview, TX, we can often come out the same day when a technician is available. New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Is it time for weather seal replacement?

  • Light showing under or around the closed door
  • Water, leaves or pests getting into the garage
  • Cracked, flattened or missing bottom rubber
  • Drafts and higher energy bills for an attached garage

What usually causes it

  • Sun and heat drying out rubber
  • Freezing to the floor and tearing
  • A worn seal retainer on older doors

What you can check yourself

  • Close the door and look for daylight along the bottom and sides.
  • Check the retainer channel on the bottom of the door to match the seal type.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our weather seal replacement process

  1. Identify the bottom retainer type (T-style, J-style or bulb)
  2. Replace the bottom seal and, if needed, the aluminum retainer
  3. Replace worn side and top perimeter stops
  4. Add a threshold seal for uneven floors
  5. Adjust the opener's close limit for a tight seal

Weather Seal Replacement cost in Plainview, TX

$100-$300Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Local weather seal replacement for Plainview, TX

Strong sun and heat in Texas dry out vinyl and rubber weather seals within a few years, leaving gaps for water, insects and the occasional snake or lizard.

Our weather seal replacement service covers Plainview (ZIP codes 79072 and 79073) and nearby towns including Seth Ward (2.1 mi), Hale Center (11.4 mi), Tulia (24.4 mi) and Olton (24.5 mi). Call (833) 435-8883 to book a visit in Plainview.

Weather Seal Replacement: frequently asked questions

How much does weather seal replacement cost in Plainview, TX?

Weather Seal Replacement typically costs $100-$300 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do weather seal replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is weather seal replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Texas or Plainview requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Plainview, TX

Sommer Garage Door Sensor Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $100-$250

Hörmann Garage Door Panel Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $300-$900

Ryobi Remote & Keypad Programming

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $50-$150

Wayne Dalton Garage Door Roller Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$350

Richards-Wilcox Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Martin Door Garage Door Cable Repair

Frayed, snapped or slipped lift cables replaced and the door re-leveled.

Typical $150-$350

Craftsman Garage Door Sensor Repair

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $100-$250

Craftsman Remote & Keypad Programming

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $50-$150

Overhead Door Off-Track Garage Door Repair

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $175-$450

High-Speed Door Repair

Fabric and rigid high-speed doors repaired and recalibrated.

Typical $400-$2,000

Hörmann Extension Spring Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $150-$350

Hörmann Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Garage door stuck, noisy or broken?

Talk to a garage door technician in Plainview, TX now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote